Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page
Filter By Grade

Continuing Education

Browse Questions

Layout and Planning of Work Questions - All Grades

You can create printable tests and worksheets from these Layout and Planning of Work questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 2 of 6 Next
Continuing Education Types of Drawings Used in Carpentry
Structural plans would generally show what information?
  1. Exterior finishes
  2. Interior finishes
  3. Rebar sizes
  4. Floor finish
Continuing Education Layout and Planning of Work
If you wanted to determine what type and use of building you're allowed to build on a piece of property what would you refer to?
  1. Zoning regulations
  2. Building by laws
  3. Building code
  4. Building regulations
Continuing Education Types of Drawings Used in Carpentry
On which drawing would you generally find set backs from property lines?
  1. Elevation view
  2. Floor plan
  3. Plot plan
  4. Section view
None Blueprints and Blueprint Reading
When ordering materials for a hand cut roof constructed of rafters and a ridge beam, where would you find the requirements for which size of dimensional lumber to use?
  1. Building by law
  2. Structural Engineer drawings
  3. Architectural drawings
  4. Cross section
Continuing Education Surveying and Plot Plans
What is the distance you are allowed to construct a building from the property line called?
  1. Building line
  2. Property measure
  3. Property line
  4. Setback
Continuing Education Layout and Planning of Work
To determine which size Douglas fir 2 x 12 you need to support a certain load of a building, what do you refer to?
  1. Building by law
  2. Building code
  3. Zoning law
  4. Manufactures specifications
None Converting Measurements
How many inches are in 152.4 mm?
  1. 4
  2. 5
  3. 6
  4. 7
Continuing Education Surveying and Plot Plans
The water connection is one utility often shown on the plot plan. What else is generally shown?
  1. Gas
  2. Sewer
  3. Electrical
  4. All of the above
Continuing Education Surveying and Plot Plans
This term is used to identify the differences in elevations and physical features of a piece of land.
  1. Topography
  2. Georaphy
  3. Geology
  4. Layout
Continuing Education Surveying and Plot Plans
25.25 feet is written on a plan. What is the equivalent of that measurement in inches?
  1. 25' 1/4"
  2. 300 1/4"
  3. 304"
  4. 303"
Previous Page 2 of 6 Next