Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page
Filter By Grade

Continuing Education

Browse Questions

Residential Framing Questions - All Grades

You can create printable tests and worksheets from these Residential Framing questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 4 of 10 Next
Continuing Education Stair Framing
You require a set of stairs to fit within a width of 13' 6"". What is the best unit run to use when laying out this set of stairs, and how many are required?
  1. 10", and 16 units
  2. 10 1/8" and 16 units
  3. 10 1/2" and 15 units
  4. 10 3/4" and 15 units
Continuing Education Stair Framing
Using the 17-18 stair proportioning formula what is the acceptable range for a tread riser if the tread width is set at 9 3/4"?
  1. 7 1/4"-8 1/4"
  2. 7"-8"
  3. Stair will not work with this formula
  4. 7 3/8"-8 3/8"
None Framing Techniques
Which of the following answers best describes post and beam construction?
  1. Structural members spaced at more than 2' on center
  2. Connection hardware is designed to be unseen
  3. Lumber is rough sawn
  4. End joints are typically finger jointed
None Roof Framing
What is the difference between a ridge board and a ridge beam?
  1. A ridge beam is designed to carry an additional load, a ridge board does not
  2. A ridge beam is used on a hip roof, and a ridge board is used on a gable roof
  3. A ridge beam is used where a ridge board can not be used
  4. There is no difference between a ridge beam and a ridge board
None Stair Framing
What is one of the most common stair proportioning formulas to help carpenters create a comfortable and safe set of steps?
  1. Rise + run = 25 degrees
  2. Rise + run = 18"
  3. Rise and run = 45 degrees
  4. Rise + run = 17"
None Wall Framing
When wood framing a house, what would be considered good practice for the top plate of the bearing partition?
  1. Ensure minimal weight is added on the wall
  2. Ensure it butts into exterior wall
  3. Add extra nails
  4. Lap the plate of the exterior wall
Previous Page 4 of 10 Next