Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page
Filter By Grade

Grade 9 Grade 10 Grade 11 Grade 12 College Continuing Education

Browse Questions

Carpentry Questions - All Grades

You can create printable tests and worksheets from these Carpentry questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 3 of 60 Next
Continuing Education Surveying and Plot Plans
A contour line identifies the
  1. size of the land.
  2. slope and elevations of the land.
  3. direction of the land.
  4. direction of the water flow on the land.
Continuing Education Hand Tools
When clamping material together, what is something that needs to be avoided to prevent damaging of material?
  1. Over clamping, which causes dents
  2. Using the wrong clamp
  3. Under clamping, which doesn't create a sufficient hold
  4. All of the above
Continuing Education Hand Tools
What are the two most common types of claw hammers that are used in carpentry?
  1. Framing
  2. Finishing
  3. Straight
  4. Roofing
Continuing Education Hand Tools
What tool would give you the most accurate reading when measuring board thickness?
  1. Metal ruler
  2. Speed square
  3. Tape measure
  4. Caliper
Continuing Education Blueprints and Blueprint Reading
In which blueprint would you find specifications about the plumbing?
  1. Architectural
  2. Structural
  3. Mechanical
  4. Electrical
None Building Materials
Where on a construction site would you find wood I joists?
  1. Floors and roofs
  2. Walls and ceilings
  3. Ceilings and floors
  4. Roofs and walls
Continuing Education Hand Tools
This type of level is small and used to check areas for plumb or level that would not require a 2' or 4' level.
  1. Mini level
  2. Torpedo level
  3. Small level
  4. Hand level
Continuing Education Blueprints and Blueprint Reading
Which drawing would you refer too when determining how to fasten the sill plate to foundation wall?
  1. Detail
  2. Floor plan
  3. Cross section
  4. Elevation
Continuing Education Hand Tools
Which of the following types of clamps will do the least damage to material when applying pressure?
  1. Spring clamp
  2. Bar clamp
  3. Band clamp
  4. Edge clamp
None Screws, Nails, and Fasteners
What tool is used to spread mastic when installing vinyl floor tiles?
  1. Notched trowel
  2. Un notched trowl
  3. Float
  4. Does not matter
None Hand Tools
Identify the tool in the image.
Carpentry Tools - Speed Square
  1. Rafter square
  2. Bevel square
  3. Framing square
  4. Speed square
None Tool Safety
What is something to check for before operating an electric power tool?
  1. Guards are in place
  2. Work are is clean and free of hazards
  3. Cords will not be affected by water
  4. All of the above
Continuing Education Building Materials
Which of the following type of engineered panel is considered structural?
  1. Particle board
  2. Medium density fibreboard
  3. Plywood
  4. Oriented strand board
Continuing Education Hand Tools
When checking for plumb on a vertical stud that has a bowed edge, where is it recommended to place the level on the stud for the most accurate reading?
  1. On the top
  2. On the bottom
  3. Along one edge in the middle
  4. With a straight edge running from the top to bottom of the stud
Previous Page 3 of 60 Next