Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page
Filter By Grade

Grade 9 Grade 11 Continuing Education

Browse Questions

Power Tools Questions - All Grades

You can create printable tests and worksheets from these Power Tools questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 1 of 4 Next
Continuing Education Power Tools
Which shop tools can be used to rip material, make miter cuts, and grooves or dados?
  1. Circular saw
  2. Chop saw
  3. Table saw
  4. Jointer
Continuing Education Power Tools
When cutting an circle into a cabinet made of 5/8" MDF what is the best tool to use?
  1. Jig saw
  2. Recipricating saw
  3. Skill saw
  4. Utility knife
Continuing Education Power Tools
What tool can be used to cut two angles at the same time?
  1. Jointer
  2. Compound miter saw
  3. Table saw
  4. Drill press
Continuing Education Power Tools
When required to drill a hole 3/4 of the way through a piece of material, what is the best drill bit to use?
  1. Auger bit
  2. Countersink bit
  3. Forstner bit
  4. Twist bit
None Power Tools
What safety feature can be found on most types of power saws?
  1. Adjustment plate
  2. Baseplate
  3. Guard
  4. Ground fault circuit interuptor
Continuing Education Power Tools
When cutting a full 4' x 8' sheet of plywood into a strips 12" wide what is the best tool to use?
  1. Table saw
  2. Jig saw
  3. Recipricating saw
  4. Hand saw
None Power Tools
When you need to do a plunge cut with a circular saw, what needs to be done to one of the safety devices on the tools?
  1. Press the safety on trigger
  2. Wear safety glasses
  3. Ensure the GFCI is connected
  4. Pull the guard back
None Power Tools
When using a table saw or jointer it is recommended to use a push stick for what reason?
  1. To add additional pressure to the material
  2. Avoid having your fingers near the blade
  3. It is the only way the tool works
  4. Prevents kickback
None Power Tools
Identify the tool in the image.
Carpentry Tools - Circular Saw
  1. Hand saw
  2. Chop saw
  3. Skill saw
  4. Circular saw
Continuing Education Power Tools
What tool is used to create holes in masonry or concrete?
  1. Powder actuated nailer
  2. Hammer drill
  3. Power drill
  4. Concrete nailer
None Power Tools
Identify the tool in the image.
Carpentry Tools - Cordless Drill
  1. Cordless drill
  2. Hand drill
  3. Power drill
  4. Impact drill
None Power Tools
Identify the tool in the image.
Carpentry Tools - Jigsaw
  1. Jig saw
  2. Reciprocating saw
  3. Circular saw
  4. Plunge saw
None Power Tools
Electric compressors should be plugged directly into the power source whenever possible because
  1. they have small cords.
  2. are loud and should be as far away from workers as possible.
  3. are very heavy and difficult to lift into place.
  4. they require a lot of power.
None Power Tools
Identify the tool in the image.
Carpentry Tools - Angle Grinder
  1. Grinder
  2. Cut off saw
  3. Hand grinder
  4. Rotating saw
Previous Page 1 of 4 Next