Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page
Filter By Grade

You are browsing Continuing Education questions. View questions in All Grades.

Grade 9 Grade 10 Grade 11 College Continuing Education

Continuing Education Carpentry Skills and Tools Questions

You can create printable tests and worksheets from these Continuing Education Carpentry Skills and Tools questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 1 of 5 Next
Continuing Education Hand Tools
Continuing Education Power Tools
Continuing Education Hand Tools
Continuing Education Hand Tools
The term plumb refers to the                 .
  1. horizontal plane
  2. vertical plane
  3. both
  4. none
Continuing Education Hand Tools
Continuing Education Hand Tools
When clamping material together, what is something that needs to be avoided to prevent damaging of material?
  1. Over clamping, which causes dents
  2. Using the wrong clamp
  3. Under clamping, which doesn't create a sufficient hold
  4. All of the above
Continuing Education Hand Tools
Continuing Education Hand Tools
If you are having difficulty pulling a nail from a piece of material, what is the most efficient way to increase the leverage of the hammer you are using?
  1. Add a block under the hammer
  2. Add a pipe to the end of the hammer
  3. Use a different hammer
  4. Drive the nail in until it protrudes to the other side
Continuing Education Hand Tools
When checking for plumb on a vertical stud that has a bowed edge, where is it recommended to place the level on the stud for the most accurate reading?
  1. On the top
  2. On the bottom
  3. Along one edge in the middle
  4. With a straight edge running from the top to bottom of the stud
Continuing Education Hand Tools
The term level refers to the                 .
  1. horizontal plane
  2. vertical plane
  3. both
  4. none
Continuing Education Building Materials
Which of the following characteristics do hardwoods trees have?
  1. Broad leafed
  2. Cone bearing
  3. Grow leaves
  4. Grow Pine needles
Continuing Education Building Materials
Which of the following type of engineered panel is considered structural?
  1. Particle board
  2. Medium density fibreboard
  3. Plywood
  4. Oriented strand board
Continuing Education Building Materials
A grading stamp will tell you which of the following on a plywood panel
  1. Span rating
  2. Class of durability
  3. Structural or non structural
  4. All of the above
Continuing Education Building Materials
What is particle board made of?
  1. Wood flakes
  2. Resin
  3. Wood dust
  4. All of the above
Continuing Education Power Tools
Continuing Education Power Tools
What tool can be used to cut two angles at the same time?
  1. Jointer
  2. Compound miter saw
  3. Table saw
  4. Drill press
Previous Page 1 of 5 Next
You need to have at least 5 reputation to vote a question down. Learn How To Earn Badges.