Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page
Filter By Grade

You are browsing Continuing Education questions. View questions in All Grades.

Grade 9 Grade 10 Grade 11 Grade 12 College Continuing Education

Browse Questions

Continuing Education Carpentry Questions

You can create printable tests and worksheets from these Continuing Education Carpentry questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 3 of 17 Next
Continuing Education Hand Tools
When checking for plumb on a vertical stud that has a bowed edge, where is it recommended to place the level on the stud for the most accurate reading?
  1. On the top
  2. On the bottom
  3. Along one edge in the middle
  4. With a straight edge running from the top to bottom of the stud
Continuing Education Architectural Features and Trim
What is the name of the molding that you see around a door or window?
  1. Base
  2. Casing
  3. Crown
  4. Astragal
Continuing Education Exterior Installation Techniques and Terminology
What kind of fasteners are acceptable for exterior decks or gazebos?
  1. Hot dipped galvanized
  2. Common
  3. Electro plated galvanized
  4. Any fasteners can be used
Continuing Education Hazardous Materials
How can lead enter your body?
  1. Breathing through the nose of mouth
  2. In cuts or abrasions on the skin
  3. Drinking or eating food contaminated with the dust
  4. All of the above
Continuing Education Building Materials
A grading stamp will tell you which of the following on a plywood panel
  1. Span rating
  2. Class of durability
  3. Structural or non structural
  4. All of the above
Continuing Education Layout and Planning of Work
What is a set of rules that specifies the standards of which all buildings are constructed called?
  1. Building code
  2. Building rules
  3. Building guidelines
  4. Building laws
Continuing Education Power Tools
What tool can be used to cut two angles at the same time?
  1. Jointer
  2. Compound miter saw
  3. Table saw
  4. Drill press
Continuing Education Hand Tools
If you wanted to cut thin metal what would be the best type of handsaw to use?
  1. Coping saw
  2. Hacksaw
  3. Crosscut saw
  4. Pull saw
Continuing Education Architectural Features and Trim
If a molded door casing is used it needs to have a mitered corner. What else can be done to ensure a clean looking finish?
  1. Do a coped joint
  2. Install plinth block between the head and side casings
  3. Use flat stock molding
  4. Use a headless pin nailer
Continuing Education Doors and Door Frames
The door jamb width is equal to the finished thickness of the                .
  1. Wall finish
  2. Door
  3. Wall
  4. Window
Continuing Education Exterior Installation Techniques and Terminology
Common nails should never be used with pressure treated or decay resistant lumber.
  1. True
  2. False
Continuing Education Types of Drawings Used in Carpentry
Why are architectural drawings often referred to as blue prints?
  1. The pens they use are blue
  2. No reason, that's what they are called
  3. An old technique that was used to create drawings
  4. The paper they use is blue
Previous Page 3 of 17 Next