Want to see correct answers?
Login or join for free!
  printable Worksheets
Looking for printable worksheets?
Check out our pre-made printable worksheets!
Share/Like This Page

Carpentry Questions - All Grades

You can create printable tests and worksheets from these Carpentry questions! Select one or more questions using the checkboxes above each question. Then click the add selected questions to a test button before moving to another page.

Previous Page 1 of 60 Next
Continuing Education Types of Wall and Ceiling Finishes
Continuing Education Hand Tools
Continuing Education Concrete Forming and Placing Tools
Continuing Education Concrete Forming and Placing Tools
Continuing Education Architectural Features and Trim
If a molded door casing is used it needs to have a mitered corner. What else can be done to ensure a clean looking finish?
  1. Do a coped joint
  2. Install plinth block between the head and side casings
  3. Use flat stock molding
  4. Use a headless pin nailer
Continuing Education Types of Drawings Used in Carpentry
When contour lines on a drawing are close together what does it tell you about the property?
  1. The property is steep
  2. The property has a gradual slope
  3. The property has good drainage
  4. The property has a lot of extra fill
Continuing Education Types of Drawings Used in Carpentry
What information would you be able to find on an exterior elevation drawing?
  1. Location of plumbing
  2. Exterior finish
  3. Room size
  4. Location of building on a piece of property
Continuing Education Types of Drawings Used in Carpentry
Continuing Education Types of Drawings Used in Carpentry
Which drawing would you generally refer to for room dimensions?
  1. Foundation plan
  2. Floor plan
  3. Structural plan
  4. Elevation view
None Tool Safety
According to Occupation Safety and Health Administration, what is recommended when you discover a tool has been damaged?
  1. Nothing is recommended by OSHA.
  2. Schedule to have it fixed and continue using.
  3. Use it carefully.
  4. Do not use the tool.
Continuing Education Hand Tools
Continuing Education Hand Tools
When checking for plumb on a vertical stud that has a bowed edge, where is it recommended to place the level on the stud for the most accurate reading?
  1. On the top
  2. On the bottom
  3. Along one edge in the middle
  4. With a straight edge running from the top to bottom of the stud
Continuing Education Hand Tools
The term plumb refers to the                 .
  1. horizontal plane
  2. vertical plane
  3. both
  4. none
Continuing Education Types of Wall and Ceiling Finishes
Generally in a suspended ceiling the hanger wire is use to support what?
  1. Ceiling lags
  2. Wall angles
  3. Cross tees
  4. Main runners
Previous Page 1 of 60 Next
You need to have at least 5 reputation to vote a question down. Learn How To Earn Badges.